Edson In-Out Conduit Idlers

Designed to increase efficiency and sensitivity of a Pull-Pull Conduit System. Engineered with 6" sheaves and three holes to accept Edson's Conduit End Fittings, the idler makes wire alignment with the sheave automatic.

It is recommended that these idlers be used at major load points in engine compartments to allow the steering cable to run over a sheave when being routed aft. Required on center cockpit pull-pull systems over 39'(12m).

Product Guidleines

  • Conduit should have no 90 degree bends on boats over 30', as it will make steering stiff
  • Use Edson Conduit Idlers whenever possible when conduit needs to make a turn
  • Conduit should be utilized only to make slight elevation changes and gentle bends
  • Conduit greasers should be used on all runs over 6'(2m)

Click Image to Zoom
Edson Idler, In-Out Conduit, 6" Aluminum Sheave w/NB
Price: $ 451.95

    © Site content copyright Mauri Pro Sailing, LLC. All rights reserved
    Site developed by Mauri Pro Sailing
    Mauri Logo